Intel >> 80386
指令集
參考資訊:
1. i386
如下:
AAA | ASCII Adjust after Addition |
AAD | ASCII Adjust AX before Division |
AAM | ASCII Adjust AX after Multiply |
AAS | ASCII Adjust AL after Subtraction |
ADC | Add with Carry |
ADD | Add |
AND | Logical AND |
ARPL | Adjust RPL Field of Selector |
BOUND | Check Array Index Against Bounds |
BSF | Bit Scan Forward |
BSR | Bit Scan Reverse |
BT | Bit Test |
BTC | Bit Test and Complement |
BTR | Bit Test and Reset |
BTS | Bit Test and Set |
CALL | Call Procedure |
CBW/CWDE | Convert Byte to Word/Convert Word to Doubleword |
CLC | Clear Carry Flag |
CLD | Clear Direction Flag |
CLI | Clear Interrupt Flag |
CLTS | Clear Task-Switched Flag in CR0 |
CMC | Complement Carry Flag |
CMP | Compare Two Operands |
CMPS/CMPSB/CMPSW/CMPSD | Compare String Operands |
CWD/CDQ | Convert Word to Doubleword/Convert Doubleword to Quadword |
DAA | Decimal Adjust AL after Addition |
DAS | Decimal Adjust AL after Subtraction |
DEC | Decrement by 1 |
DIV | Unsigned Divide |
ENTER | Make Stack Frame for Procedure Parameters |
HLT | Halt |
IDIV | Signed Divide |
IMUL | Signed Multiply |
IN | Input from Port |
INC | Increment by 1 |
INS/INSB/INSW/INSD | Input from Port to String |
INT/INTO | Call to Interrupt Procedure |
IRET/IRETD | Interrupt Return |
Jcc | Jump if Condition is Met |
JMP | Jump |
LAHF | Load Flags into AH Register |
LAR | Load Access Rights Byte |
LEA | Load Effective Address |
LEAVE | High Level Procedure Exit |
LGDT/LIDT | Load Global/Interrupt Descriptor Table Register |
LGS/LSS/LDS/LES/LFS | Load Full Pointer |
LLDT | Load Local Descriptor Table Register |
LMSW | Load Machine Status Word |
LOCK | Assert LOCK# Signal Prefix |
LODS/LODSB/LODSW/LODSD | Load String Operand |
LOOP/LOOPcond | Loop Control with CX Counter |
LSL | Load Segment Limit |
LTR | Load Task Register |
MOV | Move Data |
MOV | Move to/from Special Registers |
MOVS/MOVSB/MOVSW/MOVSD | Move Data from String to String |
MOVSX | Move with Sign-Extend |
MOVZX | Move with Zero-Extend |
MUL | Unsigned Multiplication of AL or AX |
NEG | Two's Complement Negation |
NOP | No Operation |
NOT | One's Complement Negation |
OR | Logical Inclusive OR |
OUT | Output to Port |
OUTS/OUTSB/OUTSW/OUTSD | Output String to Port |
POP | Pop a Word from the Stack |
POPA/POPAD | Pop all General Registers |
POPF/POPFD | Pop Stack into FLAGS or EFLAGS Register |
PUSH | Push Operand onto the Stack |
PUSHA/PUSHAD | Push all General Registers |
PUSHF/PUSHFD | Push Flags Register onto the Stack |
RCL/RCR/ROL/ROR | Rotate |
REP/REPE/REPZ/REPNE/REPNZ | Repeat Following String Operation |
RET | Return from Procedure |
SAHF | Store AH into Flags |
SAL/SAR/SHL/SHR | Shift Instructions |
SBB Integer | Subtraction with Borrow |
SCAS/SCASB/SCASW/SCASD | Compare String Data |
SETcc | Byte Set on Condition |
SGDT/SIDT | Store Global/Interrupt Descriptor Table Register |
SHLD | Double Precision Shift Left |
SHRD | Double Precision Shift Right |
SLDT | Store Local Descriptor Table Register |
SMSW | Store Machine Status Word |
STC | Set Carry Flag |
STD | Set Direction Flag |
STI | Set Interrupt Flag |
STOS/STOSB/STOSW/STOSD | Store String Data |
STR | Store Task Register |
SUB | Integer Subtraction |
TEST | Logical Compare |
VERR/VERW | Verify a Segment for Reading or Writing |
WAIT | Wait until BUSY# Pin is Inactive (HIGH) |
XCHG | Exchange Register/Memory with Register |
XLAT/XLATB | Table Look-up Translation |
XOR | Logical Exclusive OR |