RG351P
UART腳位
焊接如下：
Baudrate: 115200bps
U-Boot 2017.09-g2682dfc-dirty (Sep 13 2020 - 21:15:17 -0700)
Model: Rockchip RK3326 ODROID-GO2
PreSerial: 2
DRAM: 1022 MiB
Sysmem: init
Relocation Offset is: 3dbc1000
Using default environment
adc0 (hw rev) 675
no mmc device at slot 1
RKPARM: Invalid parameter part table
Found IDB in SDcard
dwmmc@ff370000: 1 (SD), dwmmc@ff390000: 0
Bootdev(atags): mmc 1
MMC1: Legacy, 50Mhz
PartType: DOS
init_resource_list: failed to get resource part, ret=-1
dtb in resource read fail, try dtb in spi flash
sfc nor id: b 40 18
Device 1: GUID Partition Table Header signature is wrong: 0xFFFFFFFFFFFFFFFF != 0x5452415020494645
Repair the backup gpt table OK!
Vendor: 0x0308 Rev: V1.00 Prod: rkflash-SpiNor
Type: Hard Disk
Capacity: 16.0 MB = 0.0 GB (32768 x 512)
... is now current device
spinor read: device 1 block # 8192, count 200 ... 200 blocks read: OK
I2c speed: 400000Hz
PMIC: RK8170 (on=0x80, off=0x80)
vdd_logic 1100000 uV
vdd_arm 1100000 uV
*** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
Model: ODROID-GO2 v1.1 for linux based on Rockchip rk3326
rockchip_get_boot_mode: Could not found misc partition
boot mode: None
CLK: (sync kernel. arm: enter 600000 KHz, init 600000 KHz, kernel 600000 KHz)
apll 600000 KHz
dpll 664000 KHz
cpll 24000 KHz
npll 1188000 KHz
gpll 1200000 KHz
aclk_bus 200000 KHz
hclk_bus 150000 KHz
pclk_bus 100000 KHz
aclk_peri 200000 KHz
hclk_peri 150000 KHz
pclk_pmu 100000 KHz
now_cap 0xbe9
** Unable to read file manufacture **
Found Charging-Low LED
Enable charge animation display
Exit charge: due to charger offline
Rockchip UBOOT DRM driver version: v1.0.1
Using display timing dts
Detailed mode clock 17000 kHz, flags[a]
H: 0320 0450 0454 0584
V: 0480 0482 0483 0485
bus_format: 100e
final DSI-Link bandwidth: 450 Mbps x 1
** Unable to read file logo.bmp **
logo.bmp file not found! filesize = 0
spinor read: device 1 block # 8392, count 400 ... 400 blocks read: OK
Uncompressed size: 460856 = 0x70838
switch to partitions #0, OK
mmc1 is current device
Net: Net Initialization Skipped
No ethernet found.
Hit key to stop autoboot('CTRL+C'): 0
switch to partitions #0, OK
mmc1 is current device
reading boot.ini
389 bytes read in 2 ms (189.5 KiB/s)
## Executing script at 00800800
Retrieving file: /extlinux/rk3326-odroidgo2-linux-v11.dtb.conf
reading /extlinux/rk3326-odroidgo2-linux-v11.dtb.conf
227 bytes read in 4 ms (54.7 KiB/s)
1: EmuELEC
Retrieving file: /KERNEL
reading /KERNEL
18747400 bytes read in 785 ms (22.8 MiB/s)
append: boot=UUID=1309-1824 disk=UUID=7d5f0e78-305f-468c-b258-6b536cf99da9 quiet console=ttyFIQ0 console=tty0 net.iframes=0 fbcon=rotate:3 ssh consoleblank=0
Retrieving file: /rk3326-odroidgo2-linux-v11.dtb
reading /rk3326-odroidgo2-linux-v11.dtb
86894 bytes read in 7 ms (11.8 MiB/s)
## Flattened Device Tree blob at 01f00000
Booting using the fdt blob at 0x1f00000
'reserved-memory' region@110000: addr=110000 size=f0000
Loading Device Tree to 0000000031d9b000, end 0000000031db336d ... OK
reserve drm-loader-logo offset = 58504
reserve drm-logo mem = 000000003df00000, size = 1662976
Adding bank: 0x00200000 - 0x40000000 (size: 0x3fe00000)
Total: 3520.51 ms
Starting kernel ...
[ 0.210742] genirq: Setting trigger mode 8 for irq 170 failed (gic_set_type+0x0/0x60)
[ 0.576154] OF: graph: no port node found in /mipi-dphy-rx0@ff2f0000
[ 0.587617] rk-vcodec vpu_combo: failed on clk_get clk_cabac
[ 0.597055] rk-vcodec vpu_combo: could not find power_model node
[ 0.621466] rockchip-drm display-subsystem: failed to bind ff450000.dsi (ops 0xffffff8008a0fc68): -517
[ 0.634434] panel-simple-dsi ff450000.dsi.0: failed to get power regulator: -517
[ 0.642497] mali ff400000.gpu: Failed to get regulator
[ 0.647697] mali ff400000.gpu: Power control initialization failed
[ 0.713255] rk817-battery rk817-battery: fb_temperature missing!
[ 0.719342] rk817-battery rk817-battery: energy_mode missing!
[ 0.725137] rk817-battery rk817-battery: zero_reserve_dsoc missing!
[ 0.755632] rk817-charger rk817-charger: power_dc2otg missing!
[ 0.761558] rk817-charger rk817-charger: otg5v_suspend_enable missing!
[ 0.790800] OF: graph: no port node found in /rkisp1@ff4a0000
[ 0.796615] rkisp1: Failed to register subdev notifier(-19)
[ 0.812637] rk_tsadcv2_temp_to_code: Invalid conversion table: code=4095, temperature=2147483647
[ 0.843059] cpu cpu0: failed to find power_model node
[ 0.925868] rockchip-dmc dmc: unable to get devfreq-event device : dfi
[ 0.935442] rksfc_base v1.1 2016-01-08
[ 0.962088] rockchip-drm display-subsystem: failed to bind ff450000.dsi (ops 0xffffff8008a0fc68): -517
[ 0.973580] mali ff400000.gpu: Failed to get leakage
[ 0.984905] rockchip-dmc dmc: Failed to get leakage
[ 0.990703] rockchip-dmc dmc: failed to get vop bandwidth to dmc rate
[ 0.997237] rockchip-dmc dmc: failed to get vop pn to msch rl
[ 1.021945] devfreq dmc: Couldn't update frequency transition information.
[ 1.032861] asoc-simple-card rk817-sound: ASoC: no sink widget found for MIC_IN
[ 1.040216] asoc-simple-card rk817-sound: ASoC: Failed to add route Mic Jack -> direct -> MIC_IN
[ 1.049037] asoc-simple-card rk817-sound: ASoC: no source widget found for HPOL
[ 1.056409] asoc-simple-card rk817-sound: ASoC: Failed to add route HPOL -> direct -> Headphone Jack
[ 1.065575] asoc-simple-card rk817-sound: ASoC: no source widget found for HPOR
[ 1.072914] asoc-simple-card rk817-sound: ASoC: Failed to add route HPOR -> direct -> Headphone Jack
[ 1.083301] devfreq ff400000.gpu: Couldn't update frequency transition information.
[ 1.085379] get_framebuffer_by_node: failed to get logo,offset
[ 1.085392] rockchip-drm display-subsystem: failed to show loader logo
RG351P:~ #